Rohde & Schwarz RTP044 - Spacewire Trigger

Protocol analysis
R&S
®
RTP
866User Manual 1337.9952.02 ─ 12
13.21.3 SpaceWire trigger
13.21.3.1 SpaceWire trigger settings
Access: [Protocol] > "Shortcuts" tab > "Setup trigger"
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Make sure that:
●
In the [Protocol] > "Setup" tab:
– The correct "Protocol" is selected.
– The data sources of the serial bus are channel signals.
●
In the "Trigger" > "Setup" tab:
– The "Trigger on" = "Single event"
– The trigger "Source" = "Serial bus".
– The correct "Serial bus" is selected.
Type
Selects the trigger type for the SpaceWire analysis.
"Control frame"
Sets the trigger to the selected control type frame.
SpaceWire (option R&S RTP-K65)