Remote control commands
R&S
®
RTP
1119User Manual 1337.9952.02 ─ 12
22 Remote control commands
This chapter describes all remote commands available for R&S RTP and provides
examples and information how to use the commands.
For further information on remote control, see Chapter 21.5, "Remote control",
on page 1104.
22.1 Conventions used in remote command description............................................1125
22.2 Finding the appropriate command........................................................................ 1125
22.3 Programming examples..........................................................................................1126
22.3.1 Display.......................................................................................................................1127
22.3.2 Automatic measurements..........................................................................................1128
22.3.3 Mask testing.............................................................................................................. 1132
22.3.4 Search....................................................................................................................... 1132
22.3.5 Data management.....................................................................................................1133
22.3.6 Protocol analysis....................................................................................................... 1139
22.4 Frequently used parameters and suffixes............................................................ 1141
22.4.1 Waveform suffix.........................................................................................................1141
22.4.2 Waveform parameter.................................................................................................1145
22.4.3 Slope parameter........................................................................................................1147
22.4.4 Polarity parameter..................................................................................................... 1147
22.4.5 Event parameter........................................................................................................1147
22.4.6 Bit pattern parameter.................................................................................................1148
22.5 Common commands...............................................................................................1149
22.6 General remote settings......................................................................................... 1153
22.7 Instrument setup..................................................................................................... 1157
22.7.1 System.......................................................................................................................1157
22.7.2 Appearance............................................................................................................... 1159
22.7.3 Display.......................................................................................................................1180
22.7.4 [Quick action] setup...................................................................................................1182
22.7.5 Save / recall...............................................................................................................1183
22.7.6 Maintenance..............................................................................................................1184
22.8 Acquisition and setup.............................................................................................1186
22.8.1 Starting and stopping acquisition.............................................................................. 1187
22.8.2 Time base..................................................................................................................1188
To Next Page
Loading...
