Acquisition and waveform setup
R&S
®
RTP
208User Manual 1337.9952.02 ─ 12
5.9.2 Setting up the signal input with autoset
Autoset is the solution for the major part of routine test-setup. It is also a good start if
you need to use more complex trigger settings. Autoset finds appropriate horizontal
and vertical scales, vertical offset, and trigger conditions to present a stable waveform.
1. Connect the probe to the input connector [Ch <n>].
The instrument recognizes the probe and turns on the channel.
2. Press the [Autoset] key.
5.9.3 Adjusting the signal input manually
1. Connect the probe to the input connector [Ch <n>].
The instrument recognizes the probe and turns on the channel.
2. Open "Menu" > "Horizontal" > "Setup" tab.
3. Set the "Time scale".
4. If you want to analyze the signal some time before or after the trigger, use the
"Position" and "Reference point" to adjust the visible section of the waveform.
5. Press the channel button corresponding to the input channel. It is illuminated with
the color of the channel waveform.
6. Open the "Menu" > "Vertical" > "Setup" tab.
7. Select the "Coupling".
8. Adjust the vertical "Scale", and the vertical "Position".
9. Proceed with the acquisition setup, see Chapter 5.9.4, "Setting the acquisition",
on page 208.
5.9.4 Setting the acquisition
Prerequisites:
●
Probes are connected.
●
Vertical and horizontal settings are adjusted.
Setting up the waveform
To Next Page
Loading...
