Rohde & Schwarz RTP044 - Mask Testing; Mask Test Definition

Remote control commands
R&S
®
RTP
1459User Manual 1337.9952.02 ─ 12
22.14 Mask testing
Some of the commands in the following chapter are asynchronous. An overlapping or
asynchronous command does not automatically finish executing before the next com-
mand starts executing. If overlapping commands must be executed in a defined order,
e.g. to avoid wrong measurement results, they must be serviced sequentially.
To prevent an overlapping execution of commands, one of the commands *OPC,
*OPC? or *WAI can be used after the command or a command set.
For more information, see:
●
www.rohde-schwarz.com/rc-via-scpi, chapter "Command Sequence and Synchro-
nization"
●
Chapter 22.3, "Programming examples", on page 1126
● Mask test definition............................................................................................. 1459
● Mask definition: user mask..................................................................................1463
● Mask definition: waveform mask.........................................................................1469
● Event actions.......................................................................................................1471
● Results................................................................................................................ 1473
● Eye mask testing.................................................................................................1476
22.14.1 Mask test definition
MTESt:ADD.................................................................................................................1459
MTESt:REMove...........................................................................................................1460
MTESt[:STATe]............................................................................................................ 1460
MTESt:RST.................................................................................................................1460
MTESt:SOURce...........................................................................................................1460
MTESt:CONDition........................................................................................................1461
MTESt:TOLerance....................................................................................................... 1461
MTESt:CTYPe.............................................................................................................1462
MTESt:FILE:NAME...................................................................................................... 1462
MTESt:FILE:SAVE....................................................................................................... 1463
MTESt:FILE:OPEN.......................................................................................................1463
MTESt:FILE:DELete.....................................................................................................1463
MTESt:ADD <MaskTestName>
Creates a new mask test definition with the specified name.
Setting parameters:
<MaskTestName> String with the name of the mask test
Example: See Chapter 22.3.3.1, "Creating a user mask", on page 1132
Usage: Setting only
Asynchronous command
Mask testing