Rohde & Schwarz RTP044 - Advanced Jitter and Noise(Option R&S RTP-K133);(Option R&S RTP-K134)

Remote control commands
R&S
®
RTP
2261User Manual 1337.9952.02 ─ 12
22.22.2 Advanced jitter and noise(Option R&S RTP-K133)/(Option
R&S RTP-K134)
This chapter contains all remote commands to set up the advanced jitter and advanced
noise analysis.
Selection of the advanced jitter measurement: ADVJitter<m>
With R&S RTP, you can configure up to two simultaneous advanced jitter measure-
ments. In manual operation, they are represented by subtabs "JA1" and "JA2" in the
"Advanced Jitter" dialog box. For remote operation, they are indicated by the suffix
ADVJitter<m>.
Remote control: ADVJitter suffix <m> Manual operation: "JA" subtab
1 to 2 correspond to "JA1" to "JA2"
● Signal.................................................................................................................. 2261
● Results................................................................................................................ 2268
● Advanced settings...............................................................................................2284
22.22.2.1 Signal
ADVJitter<m>:SIGNal:TYPE......................................................................................... 2262
ADVJitter<m>:SIGNal:SOURce..................................................................................... 2262
ADVJitter<m>:SIGNal:QUICkmeas................................................................................ 2262
ADVJitter<m>:SIGNal:BITRate......................................................................................2262
ADVJitter<m>:SIGNal:CDRMode...................................................................................2262
ADVJitter<m>:SIGNal:REFSource................................................................................. 2263
ADVJitter<m>:SIGNal:CLKSource................................................................................. 2263
ADVJitter<m>:SIGNal:EDGE.........................................................................................2263
ADVJitter<m>:SIGNal:CLEStimation..............................................................................2263
ADVJitter<m>:SIGNal:CLFFactor...................................................................................2264
ADVJitter<m>:SIGNal:CFEStimation..............................................................................2264
ADVJitter<m>:SIGNal:CLFRequency............................................................................. 2264
ADVJitter<m>:SIGNal:CLOFfset....................................................................................2264
ADVJitter<m>:SIGNal:DATRate?...................................................................................2264
ADVJitter<m>:SIGNal:SAMTime....................................................................................2265
ADVJitter<m>:SIGNal:GATE:COUPling..........................................................................2265
ADVJitter<m>:SIGNal:GATE:CURSor............................................................................ 2265
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STARt.....................................................2266
ADVJitter<m>:SIGNal:GATE:RANGe:ABSolute:STOP..................................................... 2266
ADVJitter<m>:SIGNal:GATE:RANGe:MODE...................................................................2266
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STARt.....................................................2266
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STOP......................................................2267
ADVJitter<m>:SIGNal:GATE:ZDIagram..........................................................................2267
ADVJitter<m>:SIGNal:GATE:STATe............................................................................... 2267
ADVJitter<m>:SIGNal:SERStandard..............................................................................2267
Jitter analysis and clock data recovery