Remote control commands
R&S
®
RTP
2267User Manual 1337.9952.02 ─ 12
ADVJitter<m>:SIGNal:GATE:RANGe:RELative:STOP <StopValue>
Sets the relative stop of the gate area in percent, if ADVJitter<m>:SIGNal:GATE:
RANGe:MODE is set to REL.
Suffix:
<m>
.
1..2
Parameters:
<StopValue> Range: 0 to 100
Increment: 0.1
*RST: 100
Default unit: %
ADVJitter<m>:SIGNal:GATE:ZDIagram <ZoomType>
Sets the zoom the gate is coupled to, if ADVJitter<m>:SIGNal:GATE:COUPling is
set to ZOOM.
Suffix:
<m>
.
1..2
Parameters:
<ZoomType>
ADVJitter<m>:SIGNal:GATE:STATe <State>
Enables the gating setup for the advanced jitter analysis.
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
ADVJitter<m>:SIGNal:SERStandard <SerStandardType>
Sets the serial standard. Set CUSTOM to adjust the bit rate and the bandwidth manually.
The serial standards are available only if the instrument is able to support its maximum
nominal bit rate.
Suffix:
<m>
.
1..2
Jitter analysis and clock data recovery
To Next Page
Loading...
