Remote control commands
R&S
®
RTP
1359User Manual 1337.9952.02 ─ 12
Usage: Event
CURSor<m>:MAXimum:LEFT
Sets cursor 2 to the next maximum to the left of the current position.
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:RIGHt
Sets cursor 2 to the next peak to the right (from the current position).
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
CURSor<m>:MAXimum:NEXT
Sets cursor 2 to the next smaller peak (from the current position).
Suffix:
<m>
.
1..4
Selects the cursor set.
Usage: Event
22.12 Automatic measurements
This chapter contains all remote commands to set up automatic measurements and to
analyze the measurement results.
Selection of the measurement group: MEASurement<m>
With R&S RTP you can configure up to eight simultaneous measurement groups. In
manual operation, these eight measurement groups are represented by subtabs "MG1"
to "MG8" in the "Measurements" dialog box. For remote operation, the measurement
group is indicated by the suffix MEAS<m>, containing the number of the measurement
group.
Remote control: measurement suffix <m> Manual operation: "MG" subtab
1 to 8 correspond to "MG1" to "MG8"
9, 10: do not use Not available
Automatic measurements
To Next Page
Loading...
