Rohde & Schwarz RTP044 - Configuring the Quick Measurement; Quick Measurements; Starting the Quick Measurement

Measurements
R&S
®
RTP
400User Manual 1337.9952.02 ─ 12
Remote command:
MEASurement<m>:ONViolation:RUNexec on page 1428
8.3 Quick measurements
Quick measurement performs a set of up to eight amplitude/time measurements on
one source, simply by tapping the "Quick measurement" toolbar icon. The results are
displayed in a results box. You can configure the measurement to be included in quick
measurement. The current configuration can be saved to repeat the measurement
quickly.
8.3.1 Starting the quick measurement
If the "Quick meas" icon is not visible on the toolbar, add it to the toolbar: see Chap-
ter 3.3.6.2, "Configuring the toolbar", on page 74.
1. Tap the waveform that you want to measure.
2. Tap the "Quick measurement" icon on the toolbar.
3. Tap the diagram.
The result box shows the results of the default quick measurement.
8.3.2 Configuring the quick measurement
The default configuration of the quick measurement includes already 8 amplitude mea-
surements. If these measurements do not fit the measurement task, you can modify
the selection.
1. Open "Menu" > "Measure" > "Meas Group".
2. Select the "QM" subtab.
Quick measurements