Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
956User Manual 1337.9952.02 ─ 12
●
Chapter 15.1.2, "Function generator", on page 956
●
Chapter 15.1.3, "Modulation", on page 961
●
Chapter 15.1.4, "Sweep", on page 967
●
Chapter 15.1.5, "Arbitrary", on page 968
Remote command:
WGENerator<m>:SOURce on page 2220
Copy settings from Gen1/Gen2
Copies all settings from Gen1/Gen2 and applies them to Gen2/Gen1.
Remote command:
WGENerator<m>:ACOPy on page 2220
Preset Gen1/Gen2/Patt Gen
Sets the parameters of the generator to their default values. The settings of the gener-
ators are not affected by an instrument preset.They are also not stored in the user-
defined preset.
Remote command:
WGENerator<m>:PRESet on page 2220
PGENerator:PRESet on page 2234
Message
Displays relevant messages concerning the coupling and sync settings.
15.1.2 Function generator
The R&S RTP function generator can generate input signals during testing. These sig-
nals can be used, for example, when testing circuits.
Function type
Selects the type of waveform to be generated for the function generator.
"Sine"
Generates a sine wave. You can set its Frequency and Period.
Setup of the waveform generator
To Next Page
Loading...
