Rohde & Schwarz RTP044 - Line Trigger; Trigger Qualification

Remote control commands
R&S
®
RTP
1300User Manual 1337.9952.02 ─ 12
22.9.15 Line trigger
To select the line trigger, set TRIGger<m>:SOURce[:SELect] to LINE.
TRIGger<m>:POWerline:SLOPe <Slope>
Selects the rising or falling edges of the AC power input for the trigger condition.
Suffix:
<m>
.
1..3
Only 1 = A-trigger, 2 | 3 = not available. Can be omitted.
Parameters:
<Slope> POSitive | NEGative
*RST: POSitive
Usage: Asynchronous command
22.9.16 Trigger qualification
The A-event can have its own trigger qualification. Qualification is not available for B-
and R-events (event suffix m = 2 | 3) and some trigger types.
A suffix defines the trigger type to which the qualification belongs.
Table 22-3: Trigger type suffixes
Suffix Trigger type
1 EDGE
2 GLITch
3 WIDTh
4 RUNT
5 WINDow
6 TIMeout
7 INTerval
8 Qualification is not supported (SLEWrate)
9 Qualification is not supported (SETHold)
10 STATe
11 PATTern
12 qualification is not supported (ANEDge, ext. trigger input)
13 Currently not used
14 Currently not used
15 Qualification is not supported (SERPattern)
16 Qualification is not supported (NFC)
Trigger