Acquisition and waveform setup
R&S
®
RTP
164User Manual 1337.9952.02 ─ 12
Filter on channel: On | Off
Enables the DSP filter for the correspondig input channel.
Remote command:
CHANnel<m>:DIGFilter:STATe on page 1247
Cut-off
Sets the limit frequency of the lowpass filter for input channels.
Remote command:
CHANnel<m>:DIGFilter:CUToff on page 1247
5.6 Probes
With R&S RTP digital oscilloscopes, you can use various probe types. Mostly these
probes are passive and active voltage probes. The "Probes" dialog provides all probe-
relevant information.
The instrument can detect many probes and read out the probe-specific parameters,
for example, bandwidth and attenuation.
In the "Probes" tab, you find all settings that are relevant for the connected probe.
Access: "Menu" > "Vertical" > "Probes"
Probes
To Next Page
Loading...
