Rohde & Schwarz RTP044 - Math Setup - General Settings

Waveform analysis
R&S
®
RTP
291User Manual 1337.9952.02 ─ 12
7.3.2 Math setup - general settings
You can define up to eight different math waveforms. Each waveform is defined in a
separate tab in the "Math" dialog box ("M1" to "M8").
The settings for input of mathematical formulas are described in separate chapters:
●
Chapter 7.3.3.1, "Settings in the Operator editor", on page 292
●
Chapter 7.3.5, "Filters", on page 302
●
Chapter 9.1.3, "FFT configuration settings", on page 410
●
Chapter 7.3.4, "Equation", on page 294
Display........................................................................................................................ 291
Display........................................................................................................................ 291
Display
If activated, a diagram for the defined math waveform is displayed on the touch screen.
Remote command:
CALCulate:MATH<m>:STATe on page 1337
Display
Selects the upper or lower part of the waveform for mathematic calculation, or a combi-
nation of both.
Mathematics