Rohde & Schwarz RTP044 - Content and Format of the PTT File

Protocol analysis
R&S
®
RTP
515User Manual 1337.9952.02 ─ 12
Decode results are protocol-specific. They are described in the "Decode Results"
chapter of each protocol.
Remote command:
BUS<m>:RESult on page 1549
Show binary
For each configured line, the binary signal is also displayed.
Data format
Sets the data format for the values displayed in the decode table and in the combs of
the decoded signal.
Remote command:
BUS<m>:FORMat on page 1549
Show symbols
Activates the symbols list to be used for decoding. The "Label" appear in the "Decode
results" table and in the frame captions of the decoded signal.
Remote command:
BUS<m>:SYMBols on page 1550
Load symbols
Selects and loads a label list file. Available file formats are PTT, CSV, DBC (CAN only),
and XML (FIBEX files, FlexRay only).
Label lists are protocol-specific. Their contents are described in the corresponding pro-
tocol chapters.
Remote command:
BUS<m>:NEWList on page 1550
Zoom coupling
If enabled, the decode zoom and result table are synchronized. If you select a row in
the result table, this result is shown in the decode zoom.
With "Zoom window" you can also select the zoom used for coupling.
For an introduction to zoom settings and setup, see:
●
Chapter 7.1.2, "Zoom settings", on page 274
●
Chapter 7.1.3, "Zooming for details", on page 278
Remote command:
BUS<m>:ZCOupling on page 1550
13.1.4 Content and format of the PTT file
Label lists are stored as PTT (protocol translation table) files. The PTT file format is an
extension of the CSV format (comma-separated values). You can edit it with standard
editors, for example, with MS Excel or a text editor.
Basics of protocol analysis