Rohde & Schwarz RTP044 - Displaying an XY-Diagram

Waveform analysis
R&S
®
RTP
317User Manual 1337.9952.02 ─ 12
Y-source
Defines the source to be used as the y-axis of the XY-diagram. Select one of the fol-
lowing:
●
One of the waveforms of any channel
●
A reference waveform
●
The results of a mathematical function
Remote command:
WAVeform<m>:XYCurve:YSOurce on page 1348
Constant XY-ratio
If enabled, the x- and y-axes maintain a constant ratio in the diagram.
Remote command:
WAVeform<m>:XYCurve:RATio on page 1346
Swap XY
Replaces the source of the x-axis with the source of the y-axis and vice versa.
Remote command:
WAVeform<m>:XYCurve:SWAP on page 1346
7.5.2 Displaying an XY-diagram
You can create the diagram from active waveforms with drag&drop, or use the dialog
box for setup.
To display an XY-diagram with drag&drop
Prerequisites: The source waveform for the y-axis is active in a diagram, the source
waveform for the x-axis is either active or minimized.
1. Drag the x-axis waveform to the lower middle of the diagram with the y-axis wave-
form.
2. Drop the icon when it overlaps with the Xy shown in the middle of the diagram.
XY-diagram