Rohde & Schwarz RTP044 - Event Parameter; Polarity Parameter; Slope Parameter

Remote control commands
R&S
®
RTP
1147User Manual 1337.9952.02 ─ 12
Waveform Description
TNSPectrum1 | TNSPectrum2 | DDNSpectrum1 |
DDNSpectrum2 | PNSPectrum1 | PNSPectrum2 |
RNOSpectrum1 | RNOSpectrum2
Spectrograms of the advanced jitter analysis com-
ponents (option R&S RTP-K134)
TN: total noise
DDN: data-dependent noise
PN: periodic noise
RNO: random noise
NBAThtub1 | NBAThtub2 Bathtub diagrams of the noise analysis components
(option R&S RTP-K134)
NBMeas1 | NBMeas2 Bathtub measurements of the noise analysis com-
ponents (option R&S RTP-K134)
TNTRack1 | TNTRack2 | DNTRack1 | | DNTRack2 |
DDNTrack1 | DDNTrack2 | PNTRack1 | PNTRack2 |
RNOTRack1 | RNOTRack2
Tracks of the noise analysis components (option
R&S RTP-K134)
22.4.3 Slope parameter
The slope parameter is used with several trigger and search condition commands.
Slope Description
POSitive Rising edge, that is a positive voltage change.
NEGative Falling edge, that is a negative voltage change
EITHer rising as well as the falling edge.
22.4.4 Polarity parameter
The polarity parameter is used with several trigger and search condition commands.
Polarity Description
POSitive Positive going pulses.
NEGative Negative going pulses.
EITHer Both positive and negative going pulses.
22.4.5 Event parameter
The event parameter is used with commands defining an action for mask testing, limit
checks and margin checks.
Frequently used parameters and suffixes