Rohde & Schwarz RTP044 - Edge Search Conditions; Glitch Search Conditions

Remote control commands
R&S
®
RTP
1485User Manual 1337.9952.02 ─ 12
Setting parameters:
<SearchName> String with name of the search
Usage: Setting only
Asynchronous command
22.15.3 Edge search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1484
SEARch:TRIGger:EDGE:SLOPe................................................................................... 1485
SEARch:TRIGger:EDGE:SLOPe <SearchName>,<Slope>
SEARch:TRIGger:EDGE:SLOPe? <SearchName>
Selects the edge type.
Parameters:
<Slope> POSitive | NEGative | EITHer
See Chapter 22.4.3, "Slope parameter", on page 1147.
*RST: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
22.15.4 Glitch search conditions
Trigger level setting: SEARch:TRIGger:LEVel[:VALue] on page 1484
SEARch:TRIGger:GLITch:POLarity................................................................................ 1485
SEARch:TRIGger:GLITch:RANGe................................................................................. 1486
SEARch:TRIGger:GLITch:WIDTh...................................................................................1486
SEARch:TRIGger:GLITch:POLarity <SearchName>,<Polarity>
SEARch:TRIGger:GLITch:POLarity? <SearchName>
Indicates the polarity of a pulse, that is the direction of the first pulse slope.
Parameters:
<Polarity> POSitive | NEGative | EITHer
See Chapter 22.4.4, "Polarity parameter", on page 1147.
*RST: POSitive
Parameters for setting and query:
<SearchName> Search definition
Usage: Asynchronous command
Search