Protocol analysis
R&S
®
RTP
710User Manual 1337.9952.02 ─ 12
Table 13-19: Content of the Decode results table
Column Description
State Overall state of the frame
Start Time of frame start in relation to the trigger point
Packet Type Packet type
VC Number of virtual channels
DT Data type
WC/ Data Word count or data value
Number of Packets Number of packets in the frame
Tools
Press "Display settings" in the "Deode Reults" table, to access the "Display" tab.
Remote commands
Remote commands are described in Chapter 22.17.14.3, "D-PHY decode results",
on page 1855.
13.13.5 Search on decoded D-PHY data
Using the search functionality, you can find various events in the decoded data. You
can find the same events that you can trigger on, and even many more, since several
event types can also be combined.
Before you can start the search, you have to configure the bus correctly and acquire
decoded data.
To search on decoded data, set the search source to "SerBus" for the configured proto-
col.
For general information on how to handle the search functionality, see Chapter 11,
"Search functions", on page 448.
D-PHY (ption R&S
RTP-K42)
To Next Page
Loading...
