Rohde & Schwarz RTP044 - Reference Clock

Remote control commands
R&S
®
RTP
1251User Manual 1337.9952.02 ─ 12
FORMat:BORDer <ByteOrder>
Sets the endianess.
The command is only relevant for raw data export in high definition mode (16 bit word
length).
Parameters:
<ByteOrder> LSBFirst | MSBFirst
LSB first: little endian, least significant byte first
MSB first: big endian, most significant byte first
*RST: LSBFirst
Usage: Asynchronous command
22.8.14
Reference clock
Commands are related to the external reference input on the rear panel, and the output
of the OCXO reference signal.
SENSe[:ROSCillator]:SOURce...................................................................................... 1251
SENSe[:ROSCillator]:EXTernal:FREQuency................................................................... 1251
SENSe[:ROSCillator]:SOURce <RefSource>
Enables the use of the external reference signal instead of the internal OCXO refer-
ence.
Parameters:
<RefSource> INTernal | EXTernal
*RST: INTernal
Usage: Asynchronous command
SENSe[:ROSCillator]:EXTernal:FREQuency <ExternalRef>
Sets the frequency of an external reference input signal that is connected to the exter-
nal reference input on the rear panel.
Parameters:
<ExternalRef> *RST: 10E+6
Default unit: Hz
Range is 1E+6 to 20E+6, and the increment is 1E+6.
Usage: Asynchronous command
Acquisition and setup