Rohde & Schwarz RTP044 - Configuring a Sweep Waveform; Configuring an Arbitrary Waveform

Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
983User Manual 1337.9952.02 ─ 12
4. Tap "Modulation type" and select "FM".
5. Set the "Carrier frequency" and the "Carrier period".
6. Tap "Modulation signal" and select the required waveform.
7. Depending on the selected "Modulation signal", configure the settings of the wave-
form like "Modulation freq" and "Freq deviation".
8. If necessary, change the "Output" settings or add "Noise" to the waveform.
9. Press the "Enable" button, to output the waveform at the output connector of the
waveform generator.
Generating an FSK modulated waveform
1. Open "Menu" > "Apps" > "Generators" > "Gen1".
2. Select the "Setup" tab.
3. Under "Operation mode", enable the "Modulation" button.
4. Tap "Modulation type" and select "FSK".
5. Set the "Frequency 1", "Frequency 2" and the "Hop rate".
6. If necessary, change the "Output" settings or add "Noise" to the waveform.
7. Press the "Enable" button, to output the waveform at the output connector of the
waveform generator.
15.6.3 Configuring a sweep waveform
1. Open "Menu" > "Apps" > "Generators" > "Gen1".
2. Select the "Setup" tab.
3. Under "Operation mode", enable the "Sweep" button.
4. Set the "Start frequency", the "Stop frequency" and the "Sweep time".
5. If necessary, change the "Output" settings or add "Noise" to the waveform.
6. Press the "Enable" button, to output the waveform at the output connector of the
waveform generator.
15.6.4 Configuring an arbitrary waveform
Generating an arbitrary waveform from a saved file
1. Open "Menu" > "Apps" > "Generators" > "Gen1".
2. Select the "Setup" tab.
Configuring the waveform generator