Rohde & Schwarz RTP044 - Setup - General Settings

Protocol analysis
R&S
®
RTP
512User Manual 1337.9952.02 ─ 12
●
Search on decoded signal data: For most serial protocols, you can find various
events in the decoded data. You can find the same events that you can trigger on,
and even many more, because several event types can be combined. Thus, you
get the results for the complete acquisition cycle.
13.1.1 Setup - general settings
For all protocols, configuration starts with the selection of the serial bus and the proto-
col.
Table 13-1: Configuration settings are protocol-specific. They are described in the related chapters:
ARINC 429 Chapter 13.8.2, "ARINC 429 configuration", on page 615
CAN, CAN FD Chapter 13.5.2, "CAN and CAN FD configuration", on page 556
Custom: Manchester / NRZ Chapter 13.15.2, "Custom: Manchester / NRZ configuration",
on page 746
Ethernet 10BASE-T and 100BASE-TX Chapter 13.9.2, "Ethernet configuration", on page 627
Ethernet 100BASE-T1 Chapter 13.10.2, "100BASE-T1 configuration", on page 643
Ethernet 1000BASE-T1 Chapter 13.11.2, "1000BASE-T1 configuration", on page 661
I²C Chapter 13.2.2, "I²C configuration", on page 523
LIN Chapter 13.6.2, "LIN configuration", on page 583
MDIO Chapter 13.17.2, "MDIO configuration", on page 789
MIL-1553 Chapter 13.7.2, "MIL-STD-1553 configuration", on page 599
MIPI D-PHY Chapter 13.13.2, "D-PHY configuration", on page 700
MIPI M-PHY Chapter 13.14, "M-PHY and USB SSIC (option R&S RTP-K44 and
K64)", on page 715
MIPI RFFE Chapter 13.12.2, "RFFE configuration", on page 680
SpaceWire Chapter 13.21.2, "SpaceWire configuration", on page 862
SPI Chapter 13.3.2, "SPI configuration", on page 536
UART Chapter 13.4.2.1, "UART configuration settings", on page 547
USB Chapter 13.18.2, "USB 2.0 configuration", on page 806
USB 3.1 Chapter 13.19.2, "USB 3.1 configuration", on page 836
USB PD Chapter 13.20.2, "USBPD configuration", on page 850
USB SSIC Chapter 13.14.2, "M-PHY configuration", on page 716
8b/10b Chapter 13.16.2, "8b/10b configuration", on page 775
DDR3/DDR4 Chapter 13.23.1, "DDR configuration", on page 907
Basics of protocol analysis