Rohde & Schwarz RTP044 - CAN (Option R&S RTP-K3;K9)

Remote control commands
R&S
®
RTP
1615User Manual 1337.9952.02 ─ 12
<n> *
Selects the word.
Return values:
<WordState> OK | FRSTart | FRENd | FRME | BREak | STERror | SPERror |
PRERror | INSufficient
OK: the frame is valid.
BREak:stop bit error with 0x00 word
STERror: StarT ERror, incorrect start bit
SPERror: StoP ERror, incorrect stop bit
PRERror:PaRity ERror, incorrect parity bit.
INSufficient: The frame is not completely contained in the acqui-
sition. The acquired part of the frame is valid.
*RST: OK
Usage: Query only
22.17.6 CAN (option R&S RTP-K3/K9)
● Configuration.......................................................................................................1615
● Trigger.................................................................................................................1620
● Decode results.................................................................................................... 1628
● Search settings................................................................................................... 1637
● Search results..................................................................................................... 1645
● Symbolic trigger, decode and search..................................................................1652
22.17.6.1 Configuration
BUS<m>:CAN:DATA:SOURce.......................................................................................1615
BUS<m>:CAN:TYPE....................................................................................................1616
BUS<m>:CAN:FDATa:PSTandard..................................................................................1616
BUS<m>:CAN:DATA:THReshold................................................................................... 1617
BUS<m>:CAN:TECHnology.......................................................................................... 1617
BUS<m>:CAN:BITRate.................................................................................................1617
BUS<m>:CAN:FDATa:ENABle.......................................................................................1618
BUS<m>:CAN:FDATa:DBITrate..................................................................................... 1618
BUS<m>:CAN:FDATa:SAMPlepoint............................................................................... 1618
BUS<m>:CAN:SAMPlepoint..........................................................................................1618
BUS<m>:CAN:FDATa:T1Segment................................................................................. 1619
BUS<m>:CAN:T1Segment............................................................................................1619
BUS<m>:CAN:FDATa:T2Segment................................................................................. 1619
BUS<m>:CAN:T2Segment............................................................................................1619
BUS<m>:CAN:FDATa:JWIDth....................................................................................... 1620
BUS<m>:CAN:JWIDth..................................................................................................1620
BUS<m>:CAN:DATA:SOURce <DataSource>
Sets the source of the data line that is selected with BUS<m>:CAN:TYPE.
Protocols