Rohde & Schwarz RTP044 - Page 1628

Remote control commands
R&S
®
RTP
1628User Manual 1337.9952.02 ─ 12
TRIGger<m>:CAN:FDATa:SCERror <StuffCountError>
Triggers on stuff count errors. A stuff count error occurs if th received stuff count value
does not match the value calculated from the own stuff bit count.
The trigger type TRIGger<m>:CAN:TYPE must be set to ERRC.
Only relevant for CAN FD signals in ISO standard.
Parameters:
<StuffCountError> ON | OFF
*RST: ON
22.17.6.3 Decode results
To load and acivate a label list, use:
●
BUS<m>:NEWList on page 1550
●
BUS<m>:SYMBols on page 1550
BUS<m>:CAN:FCOunt?............................................................................................... 1628
BUS<m>:CAN:FDATa:FRAMe<n>:STANdard?................................................................1629
BUS<m>:CAN:FRAMe<n>:STATus?..............................................................................1629
BUS<m>:CAN:FRAMe<n>:NDBYtes?............................................................................1630
BUS<m>:CAN:FRAMe<n>:STARt?................................................................................1630
BUS<m>:CAN:FRAMe<n>:STOP?................................................................................ 1630
BUS<m>:CAN:FRAMe<n>:SYMBol?..............................................................................1631
BUS<m>:CAN:FRAMe<n>:TYPE?.................................................................................1631
BUS<m>:CAN:FRAMe<n>:DATA?................................................................................. 1631
BUS<m>:CAN:FRAMe<n>:ACKState?...........................................................................1632
BUS<m>:CAN:FRAMe<n>:CSSTate?............................................................................ 1632
BUS<m>:CAN:FRAMe<n>:DLCState?........................................................................... 1632
BUS<m>:CAN:FRAMe<n>:IDSTate?..............................................................................1632
BUS<m>:CAN:FRAMe<n>:ACKValue?.......................................................................... 1632
BUS<m>:CAN:FRAMe<n>:BITRate?............................................................................. 1633
BUS<m>:CAN:FRAMe<n>:CSValue?.............................................................................1633
BUS<m>:CAN:FRAMe<n>:DLCValue?...........................................................................1633
BUS<m>:CAN:FRAMe<n>:IDTYpe?.............................................................................. 1634
BUS<m>:CAN:FRAMe<n>:IDValue?..............................................................................1634
BUS<m>:CAN:FRAMe<n>:BSEPosition?....................................................................... 1635
BUS<m>:CAN:FRAMe<n>:FERCause?......................................................................... 1635
BUS<m>:CAN:FRAMe<n>:SDEXport?...........................................................................1635
BUS<m>:CAN:FDATa:FRAMe<n>:SCValue?.................................................................. 1636
BUS<m>:CAN:FRAMe<n>:BYTE<o>:STATe?.................................................................1636
BUS<m>:CAN:FRAMe<n>:BYTE<o>:VALue?.................................................................1636
BUS<m>:CAN:FCOunt?
Returns the number of decoded frames of the acquisition.
Protocols