Rohde & Schwarz RTP044 - ZVC Current Settings

Acquisition and waveform setup
R&S
®
RTP
199User Manual 1337.9952.02 ─ 12
Bandwidth
Displays the bandwidth of the current channel. You can set the probe bandwidth in the
"Setup" dialog.
Remote command:
ZVC:Z<m>:V<n>:BANDwidth? on page 1237
Skew
Sets the skew, a delay value, that is known from the circuit specifics but cannot be
compensated by the instrument automatically.
Remote command:
ZVC:Z<m>:V<n>:SKEW on page 1239
Reset Overload
Resets the overload indication at the probe.
Remote command:
ZVC:Z<m>:V<n>:OVERload:RSTO on page 1238
5.7.3 ZVC current settings
Access: [App Cockpit]> "Analysis" > "Multi-channel probe"> "Setup" tab > "Setup" icon
of current channel
See also:
●
Scale
●
Offset
R&S RT-ZVC probe