Rohde & Schwarz RTP044 - DC Offset Alignment

Remote control commands
R&S
®
RTP
2238User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..2
Parameters:
<State> ON | OFF
*RST: OFF
22.19.5 DC offset alignment
GENerator:ALIGnment:DC:ABORt.................................................................................2238
GENerator:ALIGnment:DC:RESult:DATE?......................................................................2238
GENerator:ALIGnment:DC:RESult:TIME?...................................................................... 2238
GENerator:ALIGnment:DC:RESult[:STATe]?................................................................... 2238
GENerator:ALIGnment:DC[:STARt]................................................................................2239
GENerator:ALIGnment:DC:ABORt
Aborts a DC offset alignment.
Usage:
Event
Asynchronous command
GENerator:ALIGnment:DC:RESult:DATE?
Queries the date of the last performed DC offset alignment.
Return values:
<Date>
Usage: Query only
GENerator:ALIGnment:DC:RESult:TIME?
Queries the time of the last performed DC offset alignment.
Return values:
<Time>
Usage: Query only
GENerator:ALIGnment:DC:RESult[:STATe]?
Queries the result of a DC offset alignment.
Return values:
<State> PASSed | FAILed | NOALigndata
*RST: NOALigndata
Usage: Query only
Waveform generator (option R&S RTP-B6)