Search functions
R&S
®
RTP
450User Manual 1337.9952.02 ─ 12
11.2.1 Search criteria
Access: "Menu" > "Apps" > "Analysis" tab > "Search" > "Setup" tab
Enable
If you enable a search and run an acquisition, the search is performed continuously on
the acquired data until acquisition is stopped.
If acquisition is stopped and you enable a search, the data of the last acquisition is
searched.
Remote command:
SEARch:ONLine on page 1482
SEARch:ALL on page 1482
Source
Defines the waveform to be searched. The source can be any analog and digital input
signal, math or reference waveform, or track. While the instrument triggers only on real
input signals, it can search also calculated and restored waveforms.
If the source is an FFT spectrum, you can perform a frequency marker search by using
the cursor measurement and defining the peak excursion. See Chapter 8.1.3.3, "Peak
search tab", on page 328.
For some serial protocol options, search on a serial bus is available. For details, see
the relevant chapters of the "Protocol Analysis" chapter.
Search setup
To Next Page
Loading...
