Rohde & Schwarz RTP044 - Acquire Settings; Aux out; Setup Settings

Acquisition and waveform setup
R&S
®
RTP
147User Manual 1337.9952.02 ─ 12
Remote command:
SENSe[:ROSCillator]:EXTernal:FREQuency on page 1251
Use external reference
Enables the use of the external reference signal instead of the internal OCXO refer-
ence.
If an external reference is used, the frequency of the reference output signal is the
same as of the reference input signal. Otherwise, the frequency of the reference output
signal is 10 MHz, that is the frequency of the OCXO.
Remote command:
SENSe[:ROSCillator]:SOURce on page 1251
5.3.3 AUX OUT
Access: "Menu" > "Horizontal" > "Setup" tab > "Skew" > "AUX OUT" tab.
Activate 1GHz Reference
Enables the 1 GHz reference signal and sends it to the [Aux Out] connector. The signal
is required for performance test to measure the frequency of the internal calibration
signal.
Remote command:
CALibration:SOURce:FREQuency on page 1249
CALibration:SOURce:STATe on page 1249
5.4 Acquire settings
The "Acquire" dialog provides the acquisition configuration for channel and spectrum
waveforms.
5.4.1 Setup settings
The "Setup" tab in the "Acquire" dialog provides the settings for the time axis.
For background information, see Chapter 5.1.3, "Horizontal system", on page 136.
Access: "Menu" > "Acquire" > "Setup" tab.
Acquire settings