Rohde & Schwarz RTP044 - Trigger Settings for Digital Signals and Parallel Buses

Remote control commands
R&S
®
RTP
2208User Manual 1337.9952.02 ─ 12
22.18.4 Trigger settings for digital signals and parallel buses
In all TRIGger<m>:PARallel commands, the trigger suffix <m> is always 1 and can
be omitted. It selects the trigger event: Only the A-trigger is available for triggering on
digital signals and parallel buses.
● General commands.............................................................................................2208
● Edge trigger.........................................................................................................2210
● Width trigger........................................................................................................2211
● Timeout trigger.................................................................................................... 2212
● Setup & Hold trigger............................................................................................2213
● State trigger.........................................................................................................2214
● Pattern trigger..................................................................................................... 2214
● Serial pattern trigger............................................................................................2217
22.18.4.1 General commands
TRIGger<m>:SOURce[:SELect].....................................................................................2208
TRIGger<m>:PARallel:TYPE.........................................................................................2209
TRIGger<m>:PARallel:SETHold:CSOurce[:VALue].......................................................... 2210
TRIGger<m>:PARallel:STATe:CSOurce:VALue................................................................2210
TRIGger<m>:PARallel:SPATtern:CSOurce[:VALue]......................................................... 2210
TRIGger<m>:PARallel:EDGE:EXPRession[:DEFine]........................................................2210
TRIGger<m>:PARallel:WIDTh:EXPRession[:DEFine].......................................................2210
TRIGger<m>:PARallel:TIMeout:EXPRession[:DEFine].....................................................2210
TRIGger<m>:PARallel:STATe:EXPRession[:DEFine]........................................................2210
TRIGger<m>:PARallel:PATTern:EXPRession[:DEFine].....................................................2210
TRIGger<m>:PARallel:SPATtern:EXPRession[:DEFine]................................................... 2210
TRIGger<m>:SOURce[:SELect] <SourceDetailed>
Selects the source of the trigger signal.
Suffix:
<m>
.
1..3
1 = A-trigger, 2 = B-trigger, 3 = R-trigger
Available values depend on the selected trigger source. For
input channels CHAN1...4, a trigger sequence can be config-
ured.
For all other trigger sources, only suffix 1 is allowed.
Parameters:
<SourceDetailed> CHAN1 | CHANnel1 | CHAN2 | CHANnel2 | CHAN3 |
CHANnel3 | CHAN4 | CHANnel4 | EXTernanalog | SBUS | D0 |
D1 | D2 | D3 | D4 | D5 | D6 | D7 | D8 | D9 | D10 | D11 | D12 |
D13 | D14 | D15 | LOGIC | MSOB1 | MSOB2 | MSOB3 |
MSOB4 | Z1V1 | Z1V2 | Z1V3 | Z1V4 | Z1I1 | Z1I2 | Z1I3 | Z1I4 |
Z2V1 | Z2V2 | Z2V3 | Z2V4 | Z2I1 | Z2I2 | Z2I3 | Z2I4 | DIFF1 |
DIFF2 | COMMON1 | COMMON2 | LINE
Mixed signal option (MSO, R&S RTP-B1)