Rohde & Schwarz RTP044 - Page 2214

Remote control commands
R&S
®
RTP
2214User Manual 1337.9952.02 ─ 12
See also: "Setup time" on page 944
Parameters:
<SetupTime> Range: -99.8E-9 to 100E-9
Increment: 1E-9
*RST: 0
Default unit: s
Usage: Asynchronous command
22.18.4.6 State trigger
See also:
●
TRIGger<m>:PARallel:STATe:CSOurce:VALue on page 2210
●
TRIGger<m>:PARallel:STATe:EXPRession[:DEFine] on page 2210
TRIGger<m>:PARallel:STATe:CSOurce:EDGE................................................................2214
TRIGger<m>:PARallel:STATe:BIT<0..15>....................................................................... 2214
TRIGger<m>:PARallel:STATe:CSOurce:EDGE <Slope>
Sets the edge of the clock signal. The crossing of the clock edge and the logical
threshold defines the time at which the logical states and the bus value are analyzed.
Parameters:
<Slope> POSitive | NEGative | EITHer
*RST: POSitive
Usage: Asynchronous command
TRIGger<m>:PARallel:STATe:BIT<0..15> <Bit>
Sets the required state for each digital channel that is used in the bus.
Parameters:
<Bit> HIGH | LOW | DONTCARE | DONTcare
Bit value: 1 (HIGH), 0 (LOW), or X (DONTCARE = DONTcare)
Usage: Asynchronous command
22.18.4.7 Pattern trigger
TRIGger<m>:PARallel:PATTern:BIT<0..15> <Bit>
Sets the required state for each digital channel that is used in the bus.
Parameters:
<Bit> HIGH | LOW | DONTCARE | DONTcare
Bit value: 1 (HIGH), 0 (LOW), or X (DONTCARE = DONTcare)
Usage: Asynchronous command
Mixed signal option (MSO, R&S RTP-B1)