Rohde & Schwarz RTP044 - Coupling Settings

Waveform generator (Option R&S RTP-B6)
R&S
®
RTP
979User Manual 1337.9952.02 ─ 12
Remote command:
GENerator:ALIGnment:DC:RESult:DATE? on page 2238
Time
Displays the time of the last performed DC offset alignment.
Remote command:
GENerator:ALIGnment:DC:RESult:TIME? on page 2238
Overall alignment state
Displays the result of the DC offset alignment.
Remote command:
GENerator:ALIGnment:DC:RESult[:STATe]? on page 2238
15.4 Coupling settings
Access: "Wave Gen" menu > "Coupling & Sync" tab.
In the R&S RTP, you can couple certain settings of the available waveform generators.
If one of the available coupling options is enabled for one of the generators, then you
cannot change the coupled parameters at the "Setup" tab of the other generator. The
values for all coupled parameters are automatically taken from the currently selected
generator.
Generator enable
Enables the coupling of the generators, with the selected set of parameters: amplitude,
frequency and noise.
Remote command:
WGENerator<m>:COUPling:STATe on page 2239
Coupling settings