Rohde & Schwarz RTP044 - XY-Diagram

Remote control commands
R&S
®
RTP
1346User Manual 1337.9952.02 ─ 12
Return values:
<TimeRelIntRef> Range: -100E+24 to 100E+24
Increment: 1
*RST: 0
Default unit: s
Usage: Query only
Asynchronous command
Firmware/software: Version 2.70
22.10.5
XY-Diagram
WAVeform<m>:XYCurve:RATio..................................................................................... 1346
WAVeform<m>:XYCurve:STATe.....................................................................................1346
WAVeform<m>:XYCurve:SWAP.................................................................................... 1346
LAYout:SIGNal:AXIS.....................................................................................................1347
WAVeform<m>:XYCurve:XSOurce.................................................................................1347
WAVeform<m>:XYCurve:YSOurce.................................................................................1348
WAVeform<m>:XYCurve:RATio <ConstantXYRatio>
If enabled, the x- and y-axes maintain a constant ratio in the diagram.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<ConstantXYRatio> ON | OFF
*RST: ON
Usage: Asynchronous command
WAVeform<m>:XYCurve:STATe <State>
Activates an XY-waveform.
Suffix:
<m>
.
1..4
XY-diagram
Parameters:
<State> ON | OFF
*RST: OFF
Usage: Asynchronous command
WAVeform<m>:XYCurve:SWAP
Replaces the source of the x-axis with the source of the y-axis and vice versa.
Waveform analysis