Protocol analysis
R&S
®
RTP
862User Manual 1337.9952.02 ─ 12
●
Control characters containing a parity-bit, a data-control flag and the 2-bit control
code. The data control flag is set to 1 and indicates that this is a control character.
Figure 13-35: SpaceWire control characters
Also there are two control codes:
●
NULL code consisting of an Escape (ESC) and a Flow Control Token (FCT)
●
Time Code consisting of an ESC followed by a single data character
Figure 13-36: SpaceWire control codes
13.21.2
SpaceWire configuration
13.21.2.1 SpaceWire configuration settings
Access: [Protocol] > "Setup" tab > "Protocol = SpaceWire"
Make sure that the tab of the correct serial bus is selected.
SpaceWire (option R&S
RTP-K65)
To Next Page
Loading...
