Data and file management
R&S
®
RTP
488User Manual 1337.9952.02 ─ 12
12.2.2 Waveform settings
In the "Save - Waveform" dialog, the storage settings for waveform data are defined.
See also: Chapter 12.2.6, "Saving and loading waveform data", on page 500.
12.2.2.1 Waveform setup settings
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Waveform" > "Setup" tab.
Multi channel
Enables or disables the export of multiple input channels. If enabled, you can export
the data of selected input channels (Selected sources) into one file.
If disabled, you can export one "Source" on page 488 waveform.
You can reload exported multiple channels if they are stored in BIN format. The import
asks you to assign each stored waveform to a reference waveform.
Remote command:
EXPort:WAVeform:MULTichannel on page 1529
Source
Selects the waveform to be exported if "Multichannel export" is disabled.
Active waveforms of input channels, math signals, reference waveforms and advanced
jitter analysis are available for export.
Save and recall waveform data and results
To Next Page
Loading...
