Rohde & Schwarz RTP044 - Amplitude;Time Measurements

Remote control commands
R&S
®
RTP
1370User Manual 1337.9952.02 ─ 12
Example:
:MEASurement:RESult:ACTual? HAR
99.9;-6.000139236;199.8;-80.701713562;299.7;-15.528377533;399.6;-79.840820312
:MEASurement:RESult:COUNt? HAR
4
Usage: Query only
Firmware/software: Version 2.70
22.12.3 Amplitude/time measurements
The following table lists the <MeasType> parameter values with a short description.
In addition, the suffixes <n> for limit check remote commands are listed.
For a detailed description, see Chapter 8.2.5.1, "Overview of amplitude/time measure-
ments", on page 351.
Table 22-6: Amplitude and time measurements
<MeasType>
parameter value
(remote control)
Measurement
(manual opera-
tion)
Description, result Suffix
<n>
HIGH High High signal level 1
LOW Low Low signal level 2
AMPLitude Amplitude Amplitude of the signal 3
MAXimum Max Maximum value of the waveform 4
MINimum Min Minimum value of the waveform 5
PDELta Peak to peak Peak-to-peak value of the waveform 6
MEAN Mean Mean value of the waveform 7
RMS RMS RMS (Root Mean Square) value of the voltage 8
STDDev σ (S-dev) Standard deviation of the waveform 9
POVershoot Pos. overshoot Positive overshoot of a square wave 10
NOVershoot Neg. overshoot Negative overshoot of a square wave 11
AREA Area Area beneath the waveform (integral) 12
RTIMe Rise time Rise time of the left-most rising edge of the waveform. 13
FTIMe Fall time Falling time of the left-most falling edge of the waveform. 14
PPULse Pos. pulse Width of a positive pulse – a rising edge followed by a
falling edge. The measurement requires at least one
complete period of a triggered signal.
15
NPULse Neg. pulse Width of a negative pulse – a falling edge followed by a
rising edge. The measurement requires at least one
complete period of a triggered signal.
16
PERiod Period Length of the left-most signal period of the waveform 17
Automatic measurements