Data and file management
R&S
®
RTP
493User Manual 1337.9952.02 ─ 12
In this dialog, you can configure the export of the data of a running Nx Single acquisi-
tion. Select the channels and scope in the "Setup" tab.
Enable
Enables the export of all waveforms of an Nx Single acquisition into one file.
The waveform records are written in historical order one after the other, either the com-
plete records or the sections as defined in Scope. Set the number of acquisitions to be
acquired and stored with "Acquisition count". The maximum amount of data that can be
written is shown in "Max. file size".
Enabling "Data logging" stops a running acquisition. To start the logging, tap "Start
Export" on page 493 or press [Single].
Pressing "Run cont" disables data logging.
Remote command:
EXPort:WAVeform:DLOGging on page 1532
Start Export
Starts an Nx Single acquisition series and simultaneously saves the waveform data to
a file.
Remote command:
RUNSingle on page 1187 (Nx Single acquisition)
12.2.3 Histogram
Access: "Menu" key >"Save/Recall" key > "Save" tab > "Histogram"
Save and recall waveform data and results
To Next Page
Loading...
