Protocol analysis
R&S
®
RTP
841User Manual 1337.9952.02 ─ 12
6. Set the logical thresholds: Either enter user-defined values directly in the "Thresh-
old" fields, or set the thresholds to the middle reference levels with "Auto thresh-
olds".
7. Enable "Decode".
For details on configuration settings, see Chapter 13.19.2.1, "USB 3.1 configuration
settings", on page 837.
13.19.3 USB 3.1 trigger
If you need information on how to get started with triggering on USB 3.1 signals, see
Chapter 13.19.3.2, "Triggering on USB 3.1", on page 843. Otherwise proceed with the
USB 3.1 trigger settings.
If the high-speed serial pattern trigger (option R&S RTP-K140/K141) is installed, USB
3.1 Gen 1 uses it for achieving faster triggering.
13.19.3.1 USB 3.1 trigger settings
Access: [Protocol] > "Shortcuts" tab > "Setup trigger"
In this section, all trigger settings for USB 3.1 are described. The user interface of the
instrument guides you through the trigger setup.
USB 3.1 (option R&S RTP-K61/K62)
To Next Page
Loading...
