Rohde & Schwarz RTP044 - Page 843

Protocol analysis
R&S
®
RTP
843User Manual 1337.9952.02 ─ 12
Remote command:
TRIGger<m>:USBThree:FIENable on page 2063
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:ENABle on page 2063
Data
Defines for the selected field, how a data check is executed.
"Condition"
Sets the comparison condition to a specific value or a range.
"Min"
Specifies the value or sets the start value of a range.
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:USBThree:DOPerator on page 2064
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:DOPerator on page 2064
TRIGger<m>:USBThree:DMIN on page 2064
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:DMIN on page 2064
TRIGger<m>:USBThree:DMAX on page 2064
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:DMAX on page 2064
Data BitState
Defines the data bit state to be checked for the selected field. Permitted bit states are
"1", "0" or "X" (do not care).
Remote command:
TRIGger<m>:USBThree:BIT on page 2065
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:BIT on page 2065
Index
The trigger index setup consists of a comparison condition and one or two address pat-
terns.
"Condition"
Sets the comparison condition to a specific value or a range.
"Min"
Specifies the value or sets the start value of a range.
"Max"
Sets the maximum value of a range for "Condition" = "In range"/"Out
of range".
Remote command:
TRIGger<m>:USBThree:IOPerator on page 2065
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:IOPerator on page 2065
TRIGger<m>:USBThree:IMIN on page 2066
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:IMIN on page 2066
TRIGger<m>:USBThree:IMAX on page 2066
TRIGger<m>:USBThree:FRAMe<n>:FLD<o>:IMAX on page 2066
13.19.3.2 Triggering on USB 3.1
Prerequisite: A bus is configured for the USB 3.1 signal to be analyzed.
USB 3.1 (option R&S
RTP-K61/K62)