Protocol analysis
R&S
®
RTP
624User Manual 1337.9952.02 ─ 12
Table 13-11: Content of the Decode results table
Column Description
State Overall state of the frame.
Start Time of word start in relation to the trigger point
Stop Time of word stop in relation to the trigger point
Label The value of the label bytes
SDI The state of the SDI bits
DATA All 32 bits of the word.
SSM The state of the SSM bits
Label Name The label name
Data (32 bit) The value of the data bytes
Tools
Press "Display settings" in the "Deode Reults" table, to access the "Display" tab.
Remote commands
Remote commands are described in Chapter 22.17.9.3, "Decode results",
on page 1717.
13.8.6 Search on decoded ARINC 429 data
Using the search functionality, you can find various events in the decoded data, the
same events which you also can trigger on. Before you can start the search, you have
to configure the bus correctly and acquire decoded data.
To search on decoded data, set the search "Source" to the serial bus that is configured
for the protocol to be analyzed.
See also Chapter 11, "Search functions", on page 448.
13.8.6.1 ARINC 429 search setup
Access: [Protocol] > "Shortcuts" tab > "Setup search"
ARINC 429 (option R&S
RTP-K7)
To Next Page
Loading...
