Rohde & Schwarz RTP044 - Appearance

Remote control commands
R&S
®
RTP
1159User Manual 1337.9952.02 ─ 12
22.7.2 Appearance
22.7.2.1 Colors appearance
DISPlay:COLor:SIGNal<m>:COLor................................................................................ 1159
DISPlay:COLor:SIGNal<m>:ASSign...............................................................................1159
DISPlay:COLor:SIGNal<m>:USE...................................................................................1159
DISPlay:COLor:SIGNal<m>:COLor <Value>
Suffix:
<m>
.
1...218
Waveform number, see Chapter 22.4.1, "Waveform suffix",
on page 1141.
Parameters:
<Value> Decimal value of the ARGB color. Use the color dialog box on
the instrument to get the hex value of the color, and convert the
hex value to a decimal value.
0 is fully transparent black.
4278190080 (dec) = FF000000 (hex) is opaque black.
4294967295 (dec) = FFFFFFFF (hex) is opaque white.
DISPlay:COLor:SIGNal<m>:ASSign <ColorTable>
Assigns the color table to the specified signal.
Suffix:
<m>
.
1...218
Waveform number, see Chapter 22.4.1, "Waveform suffix",
on page 1141.
Parameters:
<ColorTable> Color table name to be assigned to the signal.
DISPlay:COLor:SIGNal<m>:USE <State>
If enabled, the selected waveform is displayed according to its assigned color table.
If this option is disabled, the default color table is used, i.e. the intensity of the specific
signal color varies according to the cumulative occurance of the values.
Suffix:
<m>
.
1...218
Waveform number, see Chapter 22.4.1, "Waveform suffix",
on page 1141.
Parameters:
<State> ON | OFF
Instrument setup