Rohde & Schwarz RTP044 - Gating

Remote control commands
R&S
®
RTP
1423User Manual 1337.9952.02 ─ 12
MEASurement<m>:TRACk:DATA:STYPe?
Returns the data type: TRK (track).
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Usage: Query only
MEASurement<m>:TRACk:DATA[:VALues]?
Returns the data of track points for transmission from the instrument to the controlling
computer. The data can be used in MATLAB, for example.
To set the export format, use FORMat[:DATA].
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Usage: Query only
22.12.12 Gating
MEASurement<m>:GATE[:STATe]................................................................................. 1423
MEASurement<m>:GATE:MODE...................................................................................1424
MEASurement<m>:GATE:ABSolute:STARt.....................................................................1424
MEASurement<m>:GATE:ABSolute:STOP..................................................................... 1424
MEASurement<m>:GATE:RELative:STARt.....................................................................1424
MEASurement<m>:GATE:RELative:STOP......................................................................1424
MEASurement<m>:GATE:CURSor................................................................................ 1425
MEASurement<m>:GATE:CCOupling............................................................................ 1425
MEASurement<m>:GATE:ZCOupling.............................................................................1425
MEASurement<m>:GATE:ZDIagram..............................................................................1426
MEASurement<m>:GATE:GCOupling............................................................................ 1426
MEASurement<m>:GATE[:STATe] <State>
Considers the gating settings of the source waveform for the measurement.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<State> ON | OFF
*RST: OFF
Automatic measurements