Rohde & Schwarz RTP044 - R&S RT-ZVC Overview

Acquisition and waveform setup
R&S
®
RTP
194User Manual 1337.9952.02 ─ 12
5.7.1 R&S RT-ZVC overview
5.7.1.1 Setup
Access: [App Cockpit]> "Analysis" > "Multi-channel probe" > "Setup" tab
Make sure that the tab of the correct probe is selected on the left side.
State
Enables the corresponding channel of the probe. The number of available channels
depend on the characteristics of your multi-channel power probe.
Remote command:
ZVC:Z<m>:V<n>[:STATe] on page 1239
ZVC:Z<m>:I<n>[:STATe] on page 1236
Scale
Defines the vertical scale for the channel in Volts per division. Increasing the scale
compresses the display of the signal. Within a given operation range, modifying the
scale is equivalent to scaling a display range.
For the voltmeter channels, the Scale, the Offset and the "Position" specify the operat-
ing range of the voltmeter.
Remote command:
ZVC:Z<m>:V<n>:SCALe on page 1238
ZVC:Z<m>:I<n>:SCALe on page 1234
R&S
RT-ZVC probe