Remote control commands
R&S
®
RTP
1750User Manual 1337.9952.02 ─ 12
SEARch:RESult:ETHernet:WORD<m>:SSYMbol? <SearchName>
Returns the symbolic label (or translation) of the source address of the specified word
within the search result, if the label list is enabled.
Suffix:
<m>
.
*
Query parameters:
<SearchName> String parameter
Return values:
<SrcTranslation> String parameter
Usage: Query only
SEARch:RESult:ETHernet:WORD<m>:BYTE<n>:VALue? <SearchName>
BYTE returns all data of up to 1982 bytes (not just the first 5 or 6 bytes). This is also
visible in the data table under "Show details".
Suffix:
<m>
.
*
<n> *
Selects the byte number.
Query parameters:
<SearchName> String parameter
Return values:
<FrameByteValue> Range: 0 to 255
Increment: 1
*RST: 0
Usage: Query only
22.17.11 Ethernet 100BASE-T1 (option R&S RTP-57)
● Configuration.......................................................................................................1750
● Trigger.................................................................................................................1754
● Decode results.................................................................................................... 1761
● Search settings................................................................................................... 1767
● Search results..................................................................................................... 1775
22.17.11.1 Configuration
In all BUS<m>:HBTO commands, the suffix <m> selects the serial bus.
BUS<m>:HBTO:ATTN.................................................................................................. 1751
BUS<m>:HBTO:FDAM................................................................................................. 1751
BUS<m>:HBTO:FDAP..................................................................................................1751
BUS<m>:HBTO:FDIF................................................................................................... 1752
Protocols