Rohde & Schwarz RTP044 - Settings for Cursor Measurements

Measurements
R&S
®
RTP
324User Manual 1337.9952.02 ─ 12
To add labels to cursor lines
1. Open the "Cursors" dialog box, for example, with "Menu" > "Cursor".
2. Select the subtab for the cursor set you want to configure.
3. Select the "Advanced" tab.
4. For each vertical and horizontal cursor, enter a label.
5. Select "Show labels".
8.1.2.4 Saving measurement results to file
1. Open the "Menu" and select "Save/Recall".
2. Select the "Save" tab.
3. Select "Results".
4. Select the results that you want to export.
5. Save the file.
8.1.3 Settings for cursor measurements
Cursor measurements are configured in the "Cursors" dialog box.
8.1.3.1 Setup tab
The "Setup" tab contains the settings for cursor measurements.
The cursor style and position of the measurement results is defined in the "Settings" >
"Appeareance" > "Cursor" dialog box.
Figure 8-2: Setup for cursor on 2 sources
Cursor measurements