Instrument setup
R&S
®
RTP
98User Manual 1337.9952.02 ─ 12
●
Serial buses if a protocol option is activated
●
Parallel buses if MSO option is installed
See also: Chapter 4.3.2, "Color tables", on page 98
Remote command:
DISPlay:COLor:SIGNal<m>:ASSign on page 1159
Set to default color
Resets the color of the selected waveform to the factory default.
4.3.2 Color tables
Access: "Settings" > "Appearance" > "Color" > "Edit Color Table"
Color tables define the color of the waveform pixels depending on the cumulative
occurrence of the associated values. By default, the intensity of the specific waveform
color varies according to the cumulative occurrence of the values. The more often a
value occurs, the darker the color of the data point is displayed.
The following default color tables are provided:
●
"False colors"
●
"M-Hot"
●
"M-Hsv"
●
"M-Jet"
●
"Spectrum"
●
"Single Event"
●
"Temperature"
Appearance settings
To Next Page
Loading...
