Rohde & Schwarz RTP044 - Conventions Used in Remote Command Description; Finding the Appropriate Command

Remote control commands
R&S
®
RTP
1125User Manual 1337.9952.02 ─ 12
22.27 Deprecated commands...........................................................................................2314
22.27.1 Base instrument........................................................................................................ 2315
22.27.2 Options......................................................................................................................2316
22.1 Conventions used in remote command description
The following conventions are used in the remote command descriptions:
●
Command usage
If not specified otherwise, commands can be used both for setting and for querying
parameters.
If a command can be used for setting or querying only, or if it initiates an event, the
usage is stated explicitly.
●
Parameter usage
If not specified otherwise, a parameter can be used to set a value and it is the
result of a query.
Parameters required only for setting are indicated as Setting parameters.
Parameters required only to refine a query are indicated as Query parameters.
Parameters that are only returned as the result of a query are indicated as Return
values.
●
Conformity
Commands that are taken from the SCPI standard are indicated as SCPI con-
firmed. All commands used by the R&S RTP follow the SCPI syntax rules.
●
Asynchronous commands
A command which does not automatically finish executing before the next com-
mand starts executing (overlapping command) is indicated as an Asynchronous
command.
●
Reset values (*RST)
Default parameter values that are used directly after resetting the instrument (*RST
command) are indicated as *RST values, if available.
●
Default unit
The default unit is used for numeric values if no other unit is provided with the
parameter.
22.2 Finding the appropriate command
In the following chapters, the commands are sorted according to the menu and dialog
structure of the instrument.
A list of all commands in alphabetical order ist given in the "List of Commands" at the
end of this documentation.
To find the appropriate command for a setting easily, you can use the context help:
1. Enable the "Help" icon on the toolbar.
Finding the appropriate command