Data and file management
R&S
®
RTP
502User Manual 1337.9952.02 ─ 12
6. Check the filename under "Nx single" and change it, if needed. Usually, autonam-
ing is used.
7. Tap "Start export" to start the acquisition and to save the acquired waveform data
to the specified file.
To load waveform data as a reference waveform
To reload waveform data from a previous measurement, the waveform must have been
stored as a reference waveform in a BIN file before.
The procedure is described in Chapter 7.2.1, "Working with reference waveforms",
on page 282.
12.3 Screenshots
To store the graphical results of the measurement, you can save a screenshot of the
graphic area. To document current settings, the open dialog box can be included in the
screenshot.
The "Image" toolbar icon saves the current display to a file according to the settings in
"Menu" > "Save/Recall" > "Save" tab > "Screenshot". See also "Image" on page 76.
You can configure the [Camera] key to save screenshots by a single keypress. See
also Chapter 4.5.1, "Hardkeys: function assignment", on page 116.
If a USB flash drive is connected to the instrument, the default path of the user data
directory is set to the drive letter of the USB flash drive. Thus, you save data to USB
flash drive automatically, and you can change the directory in the file explorer at any
time.
Screenshots on a computer using the Web interface
If the R&S RTP is connected to a LAN, you can create and save screenshots of the
instrument's display on a computer. See Chapter 21.3.2, "Web browser",
on page 1097.
Meta information in screenshots
The meta data of the screenshot also contains instrument information. In PNG and
JPEG files, meta information is saved as EXIF information and can be read, for exam-
ple, using the ExifTool.
Screenshots
To Next Page
Loading...
