Rohde & Schwarz RTP044 - Display

Remote control commands
R&S
®
RTP
1408User Manual 1337.9952.02 ─ 12
Parameters:
<UpperLimit> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
MEASurement<m>:HISTogram:LCHeck<n>:LOWer:MARGin <LowerMargin>
MEASurement<m>:HISTogram:LCHeck<n>:UPPer:MARGin <UpperMargin>
Define the lower and upper margins for the limit check, respectively. Margins are not as
strict as limits and must be within the valid value range. The valid range is defined
using the MEASurement<m>:HISTogram:LCHeck<n>:VALid command.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
<n> 1..18
Number of the histogram measurement, see Table 22-9.
Parameters:
<UpperMargin> Range: -100 to 100
Increment: 10E-6
*RST: 0
Usage: Asynchronous command
22.12.8 Display
MEASurement<m>:DISPlay:LEVels............................................................................... 1408
MEASurement<m>:DISPlay:RESults..............................................................................1409
MEASurement<m>:DISPlay:STYLe............................................................................... 1409
MEASurement<m>:DISPlay:HISTogram......................................................................... 1409
MEASurement<m>:DISPlay:LEVels <DisplayLevels>
If enabled, the reference levels used for the measurement are displayed in the dia-
gram.
Suffix:
<m>
.
1..10
See "Selection of the measurement group: MEASurement<m>"
on page 1359.
Parameters:
<DisplayLevels> ON | OFF
*RST: OFF
Usage: Asynchronous command
Automatic measurements