Search functions
R&S
®
RTP
466User Manual 1337.9952.02 ─ 12
If several cursor measurements are enabled, select the cursor set to be used for gat-
ing. The "Start" and "Stop" values of the gate are adjusted to the values of the cursor
line positions. The measurement is limited to the part of the waveform between the cur-
sor lines.
Remote command:
MEASurement<m>:GATE:CCOupling on page 1425
MEASurement<m>:GATE:CURSor on page 1425
11.3.2 Defining the search gate
If you create a search using the "Search" toolbar icon, you can directly define the gate
by dragging a rectangle on the diagram. Otherwise, you define the gate in the "Gate"
tab of the "Search" dialog box.
1. Open the "Menu" > "Apps" > "Analysis" tab > "Search" > "Gate" tab.
2. Select the search for which you want to define the gate.
3. Use one of the following methods:
a) Set the absolute or relative "Gate description" . Enter the start and stop values
of the gate area.
b) If a zoom area has already been defined for the waveform, couple the gate
area to the zoom area by selecting the "Couple to zoom" option. If several
zoom diagrams are defined, select the zoom diagram you want to use for gat-
ing.
4. Tap "Use gate" to enable the gate.
5. Optionally, tap "Display state" to display the gate area in the diagram.
11.4 Search display presentation
Search results are displayed in a table in the "Search Results" box. In addition, a zoom
window for a selected search result can be displayed so that you can analyze the
result in more detail.
11.4.1 Search display settings
Access: "Menu" > "Apps" > "Analysis" tab > "Search" > "Display"
Search display presentation
To Next Page
Loading...
