Protocol analysis
R&S
®
RTP
837User Manual 1337.9952.02 ─ 12
13.19.2.1 USB 3.1 configuration settings
Access: [Protocol] > "Setup" tab > "Protocol" = USB3
Make sure that the tab of the correct serial bus is selected.
Figure 13-32: Serial bus protocol configuration dialog
See also: Chapter 13.1.1, "Setup - general settings", on page 512
Protocol type
Selects the USB 3.1 protocol type.
"SuperSpeed"
USB 3.1 Gen 1 with 5 Gbit/s data rate.
"SuperSpeedPlus"
USB 3.1 Gen 2 with 10 Gbit/s data rate.
Remote command:
BUS<m>:USBThree:TYPE on page 2045
USB 3.1 (option R&S
RTP-K61/K62)
To Next Page
Loading...
