Rohde & Schwarz RTP044 - Page 1616

Remote control commands
R&S
®
RTP
1616User Manual 1337.9952.02 ─ 12
Usually, the source is one of the analog channels. Reference and math waveforms are
available as source if the trigger source is one of the analog channels but not the serial
bus.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<DataSource> C1W1 | C2W1 | C3W1 | C4W1 | M1 | M2 | M3 | M4 | M5 | M6 |
M7 | M8 | R1 | R2 | R3 | R4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 |
D7 | D8 | D9 | D10 | D11 | D12 | D13 | D14 | D15
*RST: C1W1
Usage: Asynchronous command
BUS<m>:CAN:TYPE
<SignalType>
Selects the CAN-High or CAN-Low line. Both lines are required for differential signal
transmission used by CAN.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<SignalType> CANH | CANL
*RST: CANL
BUS<m>:CAN:FDATa:PSTandard <ProtStd>
Only available for CAN FD buses. Selects whether the tested signal is an ISO CAN FD
signal or not.
Suffix:
<m>
.
1..4
Parameters:
<ProtStd> ISO | NISO
ISO
Signals are decoded according to the the ISO CAN FD protocol.
This protocol has an additional stuff count field before the CRC
sequence.
NISO
Non-ISO. Signals are decoded according to the the Bosch CAN
FD protocol.
*RST: ISO
Firmware/software: FW 3.35
Protocols