Rohde & Schwarz RTP044 - Page 1549

Remote control commands
R&S
®
RTP
1549User Manual 1337.9952.02 ─ 12
Suffix:
<m>
.
1..4
Selects the serial bus.
Usage: Event
Asynchronous command
BUS<m>:FAUToset
Starts software algorithms for determining the signal threshold levels and bitrate.
Suffix:
<m>
.
1..4
Usage: Event
Asynchronous command
BUS<m>:RESult
<ShowResultTable>
Opens a table with decoded data of the serial signal. The function affects all protocol
types and requires the option for the analyzed protocol.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ShowResultTable> ON | OFF
*RST: ON
Usage: Asynchronous command
BUS<m>:THReshold <ShwThresLines>
If ON, the threshold levels are displayed in the diagram.
Suffix:
<m>
.
1..4
Selects the serial bus.
Parameters:
<ShwThresLines> ON | OFF
*RST: OFF
Usage: Asynchronous command
BUS<m>:FORMat <DataFormat>
Sets the number format for decoded data values of the indicated serial bus. It defines
the format in the decode table, and in the combs of the decoded signal on the screen.
Protocols